EZDT17 Daughter Boards allow the user to drive a second stepper motor, bidirectional DC load or Logic level loads. One of the daughter board is simply plugged into the expansion connector located on the EZHR17EN.

Allows easy daisy-chaining of the 4 Wire Bus up to 8 drives

Allows easy daisy-chaining of the 4 Wire Bus

DF11 crimped wires
in 4 different colors, 8" length

starter kit cables

EZ17 / EZHR17 3 Hole Enclosure allows for easy mounting to NEMA 17 size motors.

EZHR17EN 4 Hole Enclosure allows for easy mounting to NEMA 17 size motors.

Heat sink for EZQUAD driver,
to allow more drive current for motors.

Converts from RS232 on PC Com Port
to 4 Wire RS485 Based EZBus

Converts from USB on PC Com Port
to 4 Wire RS485 Based EZBus

Heat sink for EZINCH stepper driver,
to allow more drive current for motors.

Heat sink for Intelli-INCH to allow more drive current for motors

Heat sink for EZ4AXIS stepper / servo driver contoller, to allow more drive current for motors.